Aircommand IBIS ROOFTOP CARAVAN Provozní pokyny

1\ INSTALLATION INSTRUCTIONS AIRCOMMAND IBIS ROOFTOP AIRCONDITIONER Suitability: The IBIS caravan rooftop aircondioner is suitable for installati

10 Fig 16 Commissioning of the unit: (see also instructions to operate controls) Turn on the circuit breaker to energise unit. The unit may b

11Set temperature a few degrees below room temperature. Note: The digital readout = actual room temp. Press down or up arrow the readout will blink

12After the delay, the compressor will start. Usually the fan will stop and will not re energize until the heat exchanger has warmed and then the fa

13 OPERATION USING THE REMOTE HANDPIECE: Be sure to point the signal transmitter at the main control on the plenum. All functions are available as p

2 Fig 2 The unit must not be installed more than 5 degrees out of level fore / aft. The 240 V 50Hz power supply must be protected with a 15 Amp

3 Before installing the unit over the square hole, clean the roof around the hole to remove any grease etc. See Fig 4.

4

5 Fig 7 Connection of power supply: See Fig. 8 The power cable can now be connected via the terminal block located on the underside

6Measure the distance from the fan discharge tube, after the unit is clamped down to the ceiling. This is dimension “A” Add 15mm which is the

7 Now the duct can be engaged with the extension duct and pushed up firmly against the ceiling. NB the extension duct should fit snuggly into the fo

8 Fig 12 Fig 13

9 Fig 14 Now fit facia to duct and screw the 4 securing screws up into the duct. Figs 12 , 13 & 14. Remove the return airfilters and